Keurig The Most Common Problem: Won’t Stop Pumping Water

Keurig The Most Common Problem: Won’t Stop Pumping Water

One common problem that some Keurig owners may experience is that their device will not stop pumping water. This can be a frustrating issue as it can lead to water overflowing and potentially damaging the machine. In this post, we will discuss the symptoms, causes, and solutions for this problem to help Keurig users troubleshoot and fix the issue.

There are several reasons why a Keurig machine might not stop pumping water. Here are a few possibilities:

  1. Clogged water line: If the water line that runs from the reservoir to the brew head becomes clogged, water will not be able to flow through properly, causing the machine to continue pumping.
  2. Failed water pump: The water pump is responsible for pushing water through the machine. If the pump is not functioning properly, it may not be able to stop pumping water.
  3. Water reservoir is empty: If the water reservoir is empty, the machine will continue to try and pump water, even though there is none to be dispensed.
  4. K-cup holder is jammed: If the k-cup holder is jammed with coffee grinds or not inserted properly into the machine, the machine may think there is a problem and continue to pump water.
  5. Electric issue: If there is an issue with the electronic controls of the machine, it may cause the machine to continue pumping water.

It is recommended to check or fix the issue or consult manufacturer’s manual. Sometimes unplugging the machine for a few minutes and plugging it back in, this can sometimes reset the machine and fix the issue.

Here are some steps that can be taken to troubleshoot and fix a Keurig not stopping water pumping issue:

  1. Run a cleaning cycle: Keurig recommends running a cleaning cycle every 3-6 months to remove mineral buildup and other impurities. This can be done by filling the reservoir with water and a cleaning solution, running the brew cycle, and then repeating the process several times with plain water to rinse.
  2. Check for blockages: Inspect the water line and the needle inside the K-Cup holder for any blockages. Clean the needle and the water line with a small brush or a pipe cleaner.
  3. Check the water reservoir: Make sure the water reservoir is properly seated and that there are no cracks or leaks.
  4. Check the pump: If the problem persist after above steps, it could be due to a malfunctioning pump. You may need to call the customer service for replacement.
  5. Manually prime the pump: If the issue is caused by an airlock, you can manually prime the pump by holding down the brew button for around 15-20 seconds.
  6. Reset the machine: Unplug the machine and let it sit for 5 minutes before plugging it back in, this may help to reset the machine and fix the problem.

These steps should help you troubleshoot and fix the problem, but if you are unable to resolve the issue or if the machine is under warranty, it is best to contact the manufacturer or a qualified repair technician for assistance.


A Keurig not stopping water pumping issue can be a frustrating problem to deal with. The symptoms include water continuously running or overflowing, strange noises coming from the machine, and an error message on the display. The causes of this problem can range from mineral buildup and blockages in the water line to a malfunctioning pump. To fix the problem, users can try running a cleaning cycle, checking for blockages, making sure the water reservoir is properly seated, and manually priming the pump. If the problem persists, it is best to contact the manufacturer or a qualified repair technician for assistance. By following these steps, you can ensure that your Keurig is in proper working order and continue to enjoy your favorite drinks.

Leave a Comment

Your email address will not be published.